Installing a Brick Paver Walkway or Brick Testing Machine

Using Installing a Brick Paver Walkway or Cement Bricks or Pavers to create a pathway or patio complements a home in a way that is unmatched. It adds a level of quality and sophistication to a house entrance that can not be accomplished with either concrete or asphalt. Brick and Pavers also can be found in various colors and shapes enabling unique color pattern and patterns to be achieved. In addition, installing a Brick or Paver pathway does not always need a pro. With some basic understanding and a relatively basic sidewalk strategy, a property owner can carrying out such a task.

The key to setting up a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be set up. In addition, string lines need to be strung on each side of the pathway.
Once the area has been dug down, 3/4" gravel stone should be laid in and tamped down tightly. Then 2" of sand, or stone dust must be spread over the gravel. Again the sand/stone dust need to be tamped down. Stone dust is preferred. The height in between the tamped down sand and the stringline should equal the density of the brick or paver.

Now that you have a stable base, position a 1" pipe or ledger board the length of the pathway on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready location. These strips will act as your walkway border and help to keep the stability and shape of the sidewalk.

The key to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again help maintain the integrity of the walkway.

When developing the sidewalk, undoubtedly bricks/pavers will require to be cut or divided. Unless you want to purchase or rent an expensive wetsaw, I would suggest acquiring a basic brick/paver splitter. It is essentially a chisel with a wide end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you wish to break the brick. Then using a hammer strike the butt end of the sculpt strongly. You might require to do this a number of times. You might also desire to turn the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within one or 2 strikes the brick/paver ought to break read more easily. If your pathway has curves you will need to buy/rent a wetsaw.

After installing the bricks, build up the outdoors edges with extra sand, and then shovel in the topsoil and load down securely.
Spread stone dust over the new pathway and sweep into the fractures. This will complete the interlocking of the bricks and help to remove any weed development.


In addition, setting get more info up a Brick or Paver sidewalk does not necessarily need a pro. The key to setting up a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, place a 1" pipe or ledger board the length of the walkway on either side of the pathway. These strips will act as your sidewalk border and help to maintain the stability and shape of the walkway. Inevitably bricks/pavers will need to be cut or divided when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *